- Stock: In Stock
- Model: PEACO-J3-SCR-LA
- SKU: PEACO-J3-SCR-LA
Features
1. The thyristor power regulator adopts multipurpose LED indication for working condition, has good quality, and a longer service life.
2. High voltage resistance available, adjustable for maximum and minimum output, more safe and reliable to use.
3. 75A, 90A, and 120A Power regulators are only suitable for resistive loads such as lamps, tubes, heaters, ovens, furnaces, etc.
4. The 3-phase SCR power regulator features automatic protective functions through a built-in fast fuse.
5. Precise temperature control, high efficiency, easy installation, and delta connection can be achieved.
6. The PCB control board of the power regulator adopts SMT production, with a separate control method, withstanding voltage, current resistance, maintenance, and no interference.
Specification
| Model | PEACO-J3-SCR-LA | |
| Rated Voltage | Three-phase 380VAC (three-phase three-wire) | |
| Rated Current* | 75A, 90A | 120A |
| Dimension (W*L*H) | 110*230*165mm | 110*280*165mm |
| Installation Dimension (W*L) | 100*160mm | 100*160mm |
| Auxiliary Power | 220V, 50Hz/60Hz | |
| Output Mode | Phase output | |
| Control Signal* | 4-20mA, 0-5V DC, 0-10V DC (three ways can be switched.) | |
| Input Impedance | 4-20mA (240Ω), 0-5V DC (30K), 0-10V DC (12K) | |
| Protection Function | Fast fuse | |
| Environment | ＜45℃ | |
| Humidity | ＜90% RH | |
| Certification | CE | |
| Weight | 4kg-6kg | |
Automatic Adjustment
Phase Control
Warning
1. The main circuit adopts a three-phase three-wire input without any phase sequence.
2. For the Y connection load, the center of Y should not be connected with the zero line, otherwise, the SCR power regulator will lose control.
3. The 3-phase SCR power regulator has inbuild a fuse for overcurrent and short-circuit protection. When a fuse is blown (the yellow light is on), first check the load for short circuits, partial discharge ignition, and other faults. After troubleshooting, open the panel to replace the fuse, please replace it with the same specification fuse, do not use the one with larger fuse amperes.
4. SCR power regulator is a product with massive current, please keep in mind that terminals (R.S.T) and (U.V.W) shall be locked tightly, otherwise, SCR will be burned by terminal heating.
5. During the use of the module, when the load power is high or there is a bad radiating condition, please consider wind cooling.
